Click on one of the following choices: |
Power+Plus Manifolds
for |
|
318*/340/360 Mopar V8 Intake Manifold This CrossWind manifold is designed so that the same model fits both 318*-340-360 engines and the late Magnum V8s. The manifold features an air space under the plenum chamber which allows air to pass through keeping the incoming fuel/air charge cooler than is possible with a conventional design manifold. |
||||
The Power+Plus
CrossWind for Mopar also features nitrous bosses, an extra water port
at the rear of the manifold and is available in a satin finish or highly
polished show finish. The manifold is designed to accept the standard
length bolts that came with your original engine. Special finishing
plugs are provided to attractively cap off the unused bolt holes. Not only is this CrossWind model loaded with extra features not found on competitive manifolds, it is also substantially less expensive than any similar manifold available for the small block Mopar V8 engine family. Available at performance retailers throughout the U.S. and Canada. *1967 and later 318’s
|